Onkyo BR-925 Instruction Manual page 76

Troubleshooting—Continued
Playback of audio CD with copy protection function (copy control function)
Noise or skip occurs during playback / Disc is not recognized and "NO DISC" is displayed / First track
is not played / Music scan takes longer time than usual / Playback starts from halfway / Some parts
cannot be played / Playback stops halfway / Display error occurs
• The audio CD has a copy protection function (copy control function). Some audio CDs use copy protection that
doesn't conform to the official CD standard. Since these are nonstandard discs, they may not play properly in the CD/
HDD receiver.
Tuner
Reception is noisy, stereo FM reception suffers from hiss, the Auto Preset function doesn't preset all
stations, or the FM STEREO indicator doesn't light up when tuned to a stereo FM station.
• Check the antenna connections (see page 17).
• Change the position of the antenna (see page 32).
• Move the CD/HDD receiver away from a nearby TV or computer.
• Move power cords and speaker cables as far away as possible from the tuner's antenna.
• Cars or airplanes can cause noisy interference.
• The radio signal will be weakened if it has to pass through a concrete wall before reaching the antenna.
• Try setting FM mode to mono (see page 36).
• When listening to an AM station, noise may be heard when you operate the remote controller.
• If none of the above improves the reception, install an outdoor antenna (see page 18).
If a power outage occurs or the power cable is disconnected:
• If the preset stations are lost, preset them again (see page 34).
• The clock and timer settings will be lost. Set the clock and timers again (see page 62).
Can't adjust the frequency of the radio.
• Use the Fast Reverse and Fast Forward [
RDS doesn't work.
• The FM station you are tuned to doesn't support RDS.
• Install an outdoor FM antenna (see page 18).
• Change the position or direction of your outdoor FM antenna (see page 18).
• Move the FM antenna as far away as possible from fluorescent lights (see page 32).
External Components
Can't record to components connected to LINE 2 or LINE3.
• The CD/HDD receiver does not output signals from LINE 2 IN from LINE 2 OUT. In the same way, signals from
LINE 3 IN are not output from LINE 3 OUT. This protects the CD/HDD receiver from malfunction or failure due to
the loop between input and output.
• If Audyssey EQ™ is active, you cannot perform recording to an external component. Deactivate Audyssey EQ™
(see page 26).
Interactive control with other Onkyo
• Make sure the
cable won't work.
• Make sure the Input Display matches the type of device that you've connected to the CD/HDD receiver (see page 45).
No sound is heard from your turntable.
• Make sure the turntable has a built-in phono equalizer.
• If the turntable doesn't have a phono equalizer built-in, you must provide one.
Record player cannot play.
• When a record player of MC cartridge type is used, a boosting transformer or head amplifier is required.
76
-capable components is not working.
cables and analog audio cables are connected correctly (see page 19). Connecting only an
]/[ ] buttons to change the frequency of the radio (see page 32).