Table of Contents
Advertisement
Connecting to a PBX
Private Branch Exchanges (PBXs) are private telephone systems
used to route calls internally, for example, in a company. When
dialling a telephone number, if a prefix (access) number is
required to open an outside line, the line is connected to a PBX.
If this MFP is going to be connected to a PBX, please make the
following changes to enable it to recognise the prefix digits in the
telephone numbers used to obtain access to the outside line.
After dialling the prefix digits, the MFP will wait until the outside
line is available (secondary dial tone detected) before dialling the
rest of the number.
1.
Press the Menu button on the control panel.
2.
Using the UP arrow key, navigate to Fax Settings and
press OK.
3.
Using the UP arrow key, navigate to Setup Fax and press
OK.
4.
Using the UP arrow key, navigate to dial prefix and press
OK.
5.
Enter your dialling prefix, then press OK to confirm.
6.
Press Return to go back to the main menu settings
screen.
Automatic redial
You can set the fax to automatically redial if the initial fax
transmission fails. The machine will redial on:
>
Line busy
>
No answer
>
Communication error
To set auto-redial:
1.
Press the Menu button to prompt the menu settings
screen.
2.
Using the UP arrow key, navigate to Fax Settings and
press OK.
3.
Using the UP arrow key, navigate to Setup Fax and press
OK.
Configuring your machine.... > 71
Advertisement
Table of Contents
