Nokia 6600 User Manual page 79

T o o l s
Options when editing access
point settings: Change,
settings, Help, and Exit.
Access points
Here you can see a short explanation
for every setting that may be needed
for different data connections and
access points.
Start to fill in the settings from the
top because depending on what data
connection you select
only certain setting fields are
available.
• Connection name
descriptive name for the
connection.
• Data bearer - The options are
GPRS, Data call, and
(GSM). Depending on what data
connection you select, only
certain setting fields are
available. Fill in all fields marked
with Must be defined, or with an
asterisk. Other fields can be left
empty, unless you have been
instructed otherwise by your
service provider.
Note: To be able to use a
data connection, the
network service provider
must support this feature,
and if necessary, activate it
for your SIM card.
80
Advanced
(Data bearer),
- Give a
High speed
Copyright © 2004 Nokia. All rights reserved.
• Access point name
data only) - The access point
name is needed to establish a
connection to the GPRS network.
You obtain the access point name
from your network operator or
service provider.
• Dial-up number
and High speed (GSM) only) - The
modem telephone number of the
access point.
• User name - Write a user name if
required by the service provider.
The user name may be needed to
make a data connection, and is
usually provided by the service
provider. The user name is often
case-sensitive.
• Prompt password
key in a new password every time
you log on to a server, or if you do
not want to save your password
to the phone, choose Yes.
• Password - A password may be
needed to make a data
connection, and is usually
provided by the service provider.
The password is often case-
sensitive. When you are writing
the password, the characters you
enter are shown briefly and then
changed to asterisks (*). The
easiest way to enter numbers is
to press and hold the digit you
want to enter, and then continue
entering letters.
(for packet
(for Data call
- If you must