Advertisement
WI850A GEM-P800 Installation Instructions
Keypad LEDs
ARMED LED DEFINITION
Armed
ON
Instant Mode
Rapid Flash
Zone in Alarm
Flashing
STATUS LED DEFINITION
Ready to be Armed
ON
Zone faulted
OFF
TROUBLE LED DEFINITION
AC Failure
Flashing
System Trouble(s)
ON
FIRE LED DEFINITION
Fire Alarm
Flashing
Fire Memory/*Fire Trbl
ON
*See Note 1
AC LED DEFINITION
AC Present
ON
AC Failure
OFF
ZONE LED DEFINITION
Faulted Zone
ON
Bypassed Zone
Slow Flash
Zone in Alarm
Flashing
N
:
OTE
* If Fire Trouble on Fire LED [96-4] has been enabled, a steady
Fire LED will indicate Fire Trouble.
8
Wi850a
page 8
Arming (System ON)
Before arming the system close all protected
zones (unless programmed as Auto-Bypass
Reentry Zones).
Enter a 4-digit Arm/Disarm
code, followed by the
key, the keypad will
provide a feedback beep for each key pressed.
If a valid Arm/Disarm code is entered, the
keypad will beep 3 times. If an incorrect Arm/
Disarm code is entered, the keypad will sound
a 1-second tone indicating an incorrect entry.
Arming without Entry Delay (Instant
Mode)
Enter the
key to eliminate the entry delay.
The ARMED LED will flash rapidly to indicate
the panel is in Instant Mode. If an Exit/Entry
Zone is tripped while the panel is in Instant
Mode the panel will go into alarm immediately.
Arming/Disarming with a Keyfob
The system can be armed by pressing the
key, and disarmed by pressing the
key on
the Keyfob. Zones programmed as Exit/Entry
Follower Zones can be bypassed when the
or
keys on the Keyfob have been pro-
grammed for Interior [81-84].
Zones pro-
grammed as Home /Away with Delay Zones can
be armed regardless of the state of the Exit/
Entry Zones when the
or
keys on the
Keyfob have been programmed for
[81-84]. To arm the system with all zones pro-
tected press the
key. Press and hold the
or
key for 1.5s to fully set the system
(The LED on the Keyfob indicate the Keyfob has
transmitted the signal).
Program Keyfob/
Keyswitch Chirp [23-4] for an audible indication
of system arming and disarming.
Arming/Disarming with a Keyswitch
The system can be armed/disarmed by using a
momentary Keyswitch wired to Zone 6. Program
Keyfob/Keyswitch Chirp [23-4] for an audible
indication of system arming and disarming.
N
:
OTE
Faulted Keyswitch or silent 24 hour zone normally do not
display at the keypad. If a silent 24 hour zone or Keyswitch
is faulted at the time of arming the faulted zone will display
only while the priority sound is ON.
Arming Instant with a Keyfob
The panel can be ARMED INSTANT when the
or
keys on the Keyfob have been
programmed for
Instant [81-84]. To arm the
system with Instant protection press the
key, then press and hold the
1.5s to arm the panel with INSTANT protection.
Disarming (System OFF)
After entering the premises through an Exit/Entry
Zone, the keypad will sound the Entry Delay
Tuesday, September 16, 1997 08:01
Full Set
or
key for
Advertisement
