Advertisement
WI850A GEM-P800 Installation Instructions
Find Mode) or saved to the LOG (see Signal
Strength Logging Mode - pg. 11).
[71-78] Wireless Transmitters
Enter the RF ID# and the point number that
is to be mapped to the zone.
Programming Example
Map point 1 of a window door transmitter with
an RF ID# of 0012B0:0 to Zone 3.
1. Enter Dealer Mode.
(
2. Enter
beeps)
(beeps)
3. Enter
4. Enter
(beeps)
Note: If the RF ID# in step 3 is not entered
correctly the keypad will emit a 1 second
tone indicating incorrect entry. Repeat steps
2 - 4 above.
[81] - [84] Wireless Keyfobs
The GEM-KF is a hand held wireless trans-
mitter capable of Arming and Disarming the
control panel and/or activating 2 Auxiliary
Functions.
To activate the auxiliary func-
tions, press and hold the
or
1.5 seconds (see WI752 for more informa-
tion).
20
Wi850a
page 20
Enter the RF ID# and AUX 1 and AUX 2
options for each Keyfob.
AUX 1 & AUX 2
Programming Options:
1 Panic
Program a 1 in the AUX 1 and/or AUX 2
option to initiate a panic alarm when the
or
buttons on the Keyfob are
pressed.
Additional programming required:
Keypad Panic (
) [20-3]
Panic Report to Telco 1[36-2] and/or Telco
3 [56-3].
Audible Panic (Optional) [21-1]
2 AUX
Program a 2 in the AUX 1 and/or AUX 2
option to initiate a AUX alarm when the
or
buttons on the Keyfob are pressed.
Additional programming required:
Keypad AUX (
) [20-2]
AUX Report to Telco 1[36-2] and/or Telco 3
[56-2].
3 Bell ON
key for
Program a 3 in the AUX 1 and/or AUX 2
option to turn the Bell ON when the
buttons on the Keyfob are pressed.
Press the
button to turn the Bell OFF.
4 PGM
Program a 4 in the AUX 1 and/or AUX 2
option to activate the PGM Output when the
or
buttons on the Keyfob are
pressed. Press the
PGM Output OFF.
5 Instant
Program a 5 in the AUX 1 and/or AUX 2
option to activate Instant Mode when the
or
buttons on the Keyfob are
pressed.
6 Access on PGM
Program a 6 in the AUX 1 and/or AUX 2
option to activate the PGM Output for 5
seconds when the
or
Keyfob are pressed.
Addition programming required:
Enable Access Output [ 23-2]
7 Full Set System
Program a 7 in the AUX 1 and/or AUX 2
option to Fully Set the System when the
and the
or
buttons on the Keyfob
or
are pressed, or when the
Tuesday, September 16, 1997 08:01
button to turn the
buttons on the
or
buttons
Advertisement
