Advertisement
WI850A GEM-P800 Installation Instructions
,QVWDOODWLRQ
Mounting the Panel
Mount the Panel close to an unswitched AC
source, a cold-water pipe ground, and a tele-
phone line connection.
Mounting the Keypad
A keypad should be located near an exit/entry
door. To remove the keypad from the backplate,
insert a small screwdriver into the slots at the
bottom of the keypad. Pull up on the screwdriver
to pop off the cover.
Up to 4 keypads can be connected on individual
wire runs with #22 AWG wire with a maximum
total cable length of 1000 feet. Each keypad
draws approximately 65 mA.
Keypad Wire Color
Control Panel Terminal
RED
12 (+PWR)
BLACK
13 (GND)
GREEN
14 (GREEN)
TABLE
1 K
W
EYPAD
IRING
Typical Fire Installation
(Where permitted by local codes)
Install smoke detectors outside each sleeping
area and on each floor, including the basement.
Install the living room and basement smoke de-
tectors near the stairway of the next upper level.
6
Wi850a
page 6
For increased protection, additional detectors
should be installed in areas other than those
required, such as the dining room, bedrooms
and utility room. Heat detectors, rather than
smoke
detectors,
are
recommended
kitchens, attics, and garages due to conditions
that may result in false alarms and improper
operation.
Refer to NFPA Standard 74 (National Fire Pro-
tection
Association,
Batterymarch
Quincy, MA 02269) for additional information,
including proper mounting methods.
FIGURE
3 Typical Fire Installation
:LULQJ
Grounding the Panel
Connect the control-panel EARTH GROUND
in
screw to a metal cold-water pipe. Do not use a
gas pipe, plastic pipe or AC ground connections.
Use at least #16 AWG wire. Connect a wire with
a ground lug crimped or soldered onto one end
and connect it to the EARTH GROUND screw in
the cabinet.
Park,
AC Power and Battery Wiring
Complete all wiring before connecting the battery
or AC Power. Do not plug the transformer into a
switched outlet.
Telephone Wiring
Wire as shown in the wiring diagram in the back
of this manual.
WARNING
The FCC restricts the use of this equipment on
certain telephone lines. Read the FCC state-
ment on the back of this manual to ensure
compliance.
Tuesday, September 16, 1997 08:01
Advertisement
