Miele G 676 Operating Instructions Manual page 44

Problem solving guide
The indicator lights "Wash/Rinse",
"Drying" and "End" (19) FLASH at
the same time:
Water inlet fault
The dishwasher stops during the pro-
gramme.
– The stopcock is shut.
– The filter in the screw connection of
the valve on the water inlet hose is
blocked – see "Cleaning and care".
– Too little water flows into the wash
cabinet. This may be due to insuffi-
cient water pressure at the intake
(flow pressure at the water inlet).
In this case the water inlet time can
be extended – see the section "Ex-
tending the water inlet time".
Before removing the obstruction:
Turn the programme selector to
STOP.
Switch off the dishwasher with the
ON / OFF button.
44
Water drainage fault
The dishwasher stops during the pro-
gramme. There may be water left in the
wash cabinet.
– The drain hose is kinked.
– The drain pump is blocked – see
"Cleaning and care".
– Foreign bodies are obstructing the
non-return valve – see "Cleaning and
care".
Before removing the obstruction:
Turn the programme selector to
STOP.
Switch off the dishwasher with the
ON / OFF button.
If the indicator lights still flash when you
start a new programme, or if the cause
for them to flash was not one of those
listed here, there may be a technical
fault.
Please call the Service department.
In some cases the PRE-WASH pro-
gramme can still be carried out in spite
of this technical fault.