Uploading Firmware And Configuration Files; Figure 25-4 Restore Using Ftp Session Example - ZyXEL Communications Prestige 660R User Manual

Step 4.
Enter your password as requested (the default is "1234").
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Find the "rom" file (on your computer) that you want to restore to your Prestige.
Step 7. Use "put" to transfer files from the Prestige to the computer, for example, "put config.rom rom-0"
transfers the configuration file "config.rom" on your computer to the Prestige. See earlier in this
chapter for more information on filename conventions.
Step 8. Enter "quit" to exit the ftp prompt. The Prestige will automatically restart after a successful
restore process.
25.3.2 Restore Using FTP Session Example
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to section 25.2.5 to read about configurations that disallow TFTP and FTP over WAN.

25.4 Uploading Firmware and Configuration Files

This section shows you how to upload firmware and configuration files. You can upload configuration files
by following the procedure in the previous Restore Configuration section or by following the instructions in
Menu 24.7.2 – System Maintenance – Upload System Configuration File.
DO NOT INTERRUPT THE FILE TRANSFER PROCESS AS THIS MAY
25.4.1 Firmware File Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
Firmware and Configuration File Maintenance

Figure 25-4 Restore Using FTP Session Example

PERMANENTLY DAMAGE YOUR PRESTIGE.
Prestige 660R ADSL 2+ Access Gateway
WARNING!
25-7