Table of Contents
Advertisement
This chapter explains how to access and navigate the System Management Terminal and gives an
13.1 SMT Introduction
The Prestige's SMT (System Management Terminal) is a menu-driven interface that you can access from a
terminal emulator over a telnet connection. This chapter shows you how to access the SMT (System
Management Terminal) menus via Telnet, how to navigate the SMT and how to configure SMT menus.
13.1.1 Procedure for SMT Configuration via Telnet
The following procedure details how to telnet into your Prestige.
Step 1.
In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.1" (the default IP address) and click OK.
Step 2.
Enter "1234" in the Password field.
Step 3.
After entering the password you will see the main menu.
Please note that if there is no activity for longer than five minutes (default timeout period) after you log in,
your Prestige will automatically log you out. You will then have to telnet into the Prestige again.
13.1.2 Entering Password
The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.
For your first login, enter the default password "1234". As you type the password, the screen displays an
asterisk "*" for each character you type.
Please note that if there is no activity for longer than five minutes after you log in, your Prestige will
automatically log you out.
Introducing the SMT
Introducing the SMT
Enter Password : ****
Figure 13-1 Login Screen
Prestige 660R ADSL 2+ Access Gateway
Chapter 13
overview of its menus.
13-1
Advertisement
Table of Contents
Troubleshooting
