Table of Contents
Advertisement
11.4.1 Firmware Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
system.
Warning: Proceeding with the upload will erase the current system
firmware.
11.4.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
4. After successful firmware upload, enter "atgo" to restart the
Warning:
1. Proceeding with the upload will erase the current
2. The system's console port speed (Menu 24.2.2) may change
3. When uploading the DEFAULT configuration file, the console
To transfer the firmware and the configuration file, follow these examples:
Firmware and Configuration File Maintenance
Do You Wish To Proceed? (Y/N)
Figure 11-6 Menu 24.7.1 – Upload System Firmware
Xmodem upload on your terminal.
system.
configuration file.
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed? (Y/N)
Figure 11-7 Menu 24.7.2 – System Maintenance
Prestige 650H-17 ADSL Router
11-7
Advertisement
Table of Contents
Troubleshooting
