Using Ftp To Upload The Firmware And Configuration Files - ZyXEL Communications P-660R-Tx v2 Series Support Notes

[cppwu@faelinux cppwu]$ tftp

3. Using FTP to Upload the Firmware and Configuration Files

In addition to upload the firmware and configuration file via the console port
and TFTP client, you can also upload the firmware and configuration files to
the Prestige using FTP.
To use this feature, your workstation must have a FTP client software. See the
example shown below.
• Using FTP client software
Note: The remote file name for the firmware is 'ras' and the configuration file is
'rom-0'.
Use FTP client from your workstation to connect to the Prestige by
Step 1
entering the IP address of the Prestige.
Press 'Enter' key to ignore the username, because the Prestige does
Step2
not check the username.
Enter the CLI password as the FTP login password, the default is
Step 3
'admin'.
Step 4 Enter command 'bin' to set the transfer type to binary.
Step 5 Use 'put' command to transfer the file to the Prestige.
Example:
Step 1: Connect to the Prestige by entering the Prestige's IP and Administrator
password in the FTP software. Set the transfer type to 'Auto-Detect' or
All contents copyright © 2006 ZyXEL Communications Corporation.
-I 192.168.1.1 put [local-ras] ras
P-660R-Tx v2 Series Support Notes
<- upload firmware
73