Prestige 650M-6x User's Guide
2.1.3 Exit
Type exit at the command prompt to disconnect from the Prestige.
2.2
Connect to your Prestige Using Telnet
The following procedure details how to telnet into your Prestige.
Step 1.
Make sure your computer IP address and the Prestige IP address are on the same subnet. Refer to
the Setting Up Your Computer IP Address appendix.
Step 2.
In Windows, click Start (usually in the bottom left corner), Run and then type "telnet
192.168.1.1" (the default IP address) and click OK.
Step 3.
For your first login, enter "1234" in the Password field. As you type a password, the screen
displays an asterisk " * " for each character you type.
Step 4.
After entering the correct password you can use the commands to do configuration.
2.3
Resetting the Prestige
If you forget your password or cannot access the Prestige, you will need to use the RESET button at the back
of the Prestige to reload the factory-default configuration file. This means that you will lose all
configurations that you had previously and the password will be reset to "1234".
2.3.1 Using The Reset Button
Step 1.
Make sure the PWR/SYS LED is on (not blinking).
Step 2.
Press the RESET button for more than five seconds or until the PWR/SYS LED begins to blink
and then release it. When the PWR/SYS LED begins to blink, the defaults have been restored
and the Prestige restarts.
2.4
Changing the Password
It is highly recommended that you change the password for accessing the Prestige.
Change the Prestige default password by using the command shown next. Make sure you store the password
in a safe place.
Syntax:
sys password <new password>
2-2
Password: ****
Figure 2-3 Login Screen
Commands Introduction