7.9
Remote node Configuration
Syntax:
wan node index [1-2]
Use this command to set a remote node as the current node to apply node commands.
An example is shown next.
Syntax:
wan node clear
This command clears the current nodes statistics.
An example is shown next.
Syntax:
wan node save
This command saves the current nodes statistics.
An example is shown next.
Syntax:
wan node ispname <name>
Use this command to identify the ISP used by this node. You can check the current name by using the wan
node display command.
An example is shown next.
WAN Setup
ras> wan node index 1
Figure 7-1 wan node index
ras> wan node clear
Figure 7-2 wan node clear
ras> wan node save
Figure 7-3 wan node save
Prestige 650M-6x User's Guide
7-5