Supported Vs. Generic Transmitters - Fluke HART 744 User Manual

744
HART Mode Users Guide

Supported vs. Generic Transmitters

The calibrator communicates with virtually all HART
transmitters. In addition, the calibrator is programmed to
use device-dependent commands for a selection of HART
transmitters and their software versions. These are
"supported transmitters." All other transmitters are
"generic."
Table 1 shows the operations that are available for
supported vs. generic transmitters in single point and
multidrop configurations.
Sensor trim is provided for supported
transmitters, with a few exceptions, as identified
in the list of supported transmitters that you can
view on the display.
To display a list of supported transmitters and software
versions:
1. If the calibrator is connected to a HART transmitter
with the Active Device screen showing, press the
softkey, followed by
Abort
6
Note
.
More Choices
2. If the calibrator is not connected to a HART
transmitter, press the r key followed by
.
Choices
3. Press the
Device Revs
appears.
Press u or d to highlight the desired manufacturer,
4.
and press e. A list of model numbers appears.
Press u or d to highlight the model number, and
5.
press e. A list of software versions appears.
More
softkey. The Browser screen
pe07s.bmp