Southbend StratoSteam STRE-3D Owner's Manual page 6

S
PECIFICATIONS
E R
LECTRICAL EQUIREMENTS
One fused electrical connection is required to the contactor of each steamer. All steamers are shipped per customer
order, three phase or single phase. (A kit is available for field conversion to three phase or single phase.) The fused
connection must be wired for the required voltage and maximum amperage as listed in the chart below:
Voltage
208 V 60 Hz
220 V 50/60 Hz
240 V 60 Hz
480 V 60 Hz
W R
ATER EQUIREMENTS
To meet warranty requirements, the water supply must be as follows:
Connection
Pressure
Total Dissolved Solids (TDS)
Hardness
pH
Chlorine and/or bromine
Maximum Fill Capacity
Typical usage is 0.46 gallons per minute at 45 PSI.
In order to minimize service problems and to meet the warranty requirements, a water treatment system (softener) is
recommended when water quality does not meet the limits stated above.
If the split-water-line option is ordered, about one-fifth of the water used is treated water (used to produce steam)
while the rest is untreated water (used to cool the condensate before it leaves the drain).
D R
RAIN EQUIREMENTS
The drain outlet has a 1" NPT female connector. Do NOT directly connect the drain to a plumbing system unless you
also install an "open funnel" downstream of this connection (see Figure 7 on page 16). There must be no back-flow or
back-pressure into the drain connection!
P 6 56
AGE OF
Total Connected Amps
Model STRE-3D
1 Phase 3 Phase
44 26
41 24
38 22
19 11
1/4" compression, cold water
30 to 60 PSI
60 PPM or less
2 grains (35 PPM) or less
7.0 to 7.5
1 PPM or less
0.87 gallons
S S E
TRATO TEAM LECTRIC
Model STRE-5D
1 Phase 3 Phase
53 31
51 29
46 27
23 14
O ' M 1189951 (10/08)
WNER S ANUAL
C S
OUNTERTOP TEAMER