Southbend StratoSteam STRE-3D Owner's Manual page 13

S S E C
TRATO TEAM LECTRIC
S 2 : A L
TEP A TTACH
A set of four legs is packed with steamers ordered with legs.
A threaded hole is located at each corner. Each leg has a corresponding mating thread. The legs can be adjusted to
overcome a slightly uneven surface.
1. Raise the steamer sufficiently to allow the legs to be attached. For safety, "shore up" and support the steamer
with an adequate blocking arrangement strong enough to support the load.
2. Screw the legs into the holes (see Figure 4). Note that the front legs are different than the rear legs.
3. Lower the steamer gently onto a level surface. Never drop or allow the steamer to fall.
4. Make sure that the steamer is level (both side-to-side and front-to-back). If necessary, adjust the height of each
leg by turning the foot-pad of the leg.
5. Go on to Installation Step 3.
Figure 4
Attach Legs
O '
WNER S
S
OUNTERTOP TEAMER
EGS
M 1189951 (10/08)
ANUAL
I
NSTALLATION
P 13 56
AGE OF