To Check The Ballast - ACR Electronics RCL-600 Trouble Shooting And Parts Replacement Manual

2. Method to check the ballast
2-1 Use the following tools
・Philips screw driver
・6mm Hexagonal wrench
・DC Multimeter
2-2 Procedures to check
Remove the power head according to the instruction on page 7 "How to remove the power head".
1)
2) Loosen and remove 2 screws as indicated in picture 3 and remove the card edge receptacle from
inside the search light. (See picture 3)
3) Remove 2 cable plugs on the ballast, as indicated in picture 4.
4) Take the card edge receptacle and plug into the Ballast P.C.B. assembly (Refer picture 4)
Plug-in P.C.B.
9V
24V
Picture 3
Picture 4
8