12. Procedure to check the rotation gear
12-1 Use the following tools
・Phillips head screw driver
・4mm Hexagonal wrench
・8mm Box wrench
・3mm Hexagonal wrench
・Tube of „Loctite‟ („Slip‟ prevention fluid)
12-2 Procedure
1) Remove the search light and place upside down on a suitable surface.
2)
Loosen and remove 8 screws as indicated in picture 38. Carefully lift the bottom cover off the base.
3) Remove cables connected to the printed circuit board.
Remove the bottom cover. (
Picture 38
)
Refer picture 39
Picture 39
27