4. Method to replace the ballast
4-1 Use the following tools
・Phillips screw driver
・Pliers
・7mm flat spanner
・6mm Hexagonal wrench
・Silicon compound
・Ballast (PXE-150-DC24)
4-2 Procedure for exchanging the PCBs
1) Remove the power head according to the instruction on page 7.
2) Remove the spring with pliers as indicated by the arrow in picture 8.
3)
Remove cables connected to the starter. See picture 9.
Note: Remove cables after marking them in order to replace them in their proper order.
Picture 8
Picture 9
11