Installation - Mitsubishi Electric Melservo-J3 Series MR-J3-B Instruction Manual

13. SERVO AMPLIFIERS WITH A LARGE CAPACITY (30k TO 55kW)

13.2 Installation

CAUTION
Stacking in excess of the limited number of products is not allowed.
Install the equipment to incombustibles. Installing them directly or close to
combustibles will led to a fire.
Install the equipment in a load-bearing place in accordance with this Instruction
Manual.
Do not get on or put heavy load on the equipment to prevent injury.
Use the equipment within the specified environmental condition range. (For the
environmental conditions, refer to section 13.1.3.)
Provide an adequate protection to prevent screws, metallic detritus and other
conductive matter or oil and other combustible matter from entering the converter
unit drive unit.
Do not block the intake/exhaust ports of the converter unit
a fault may occur.
Do not subject the converter unit
are precision equipment.
Do not install or operate a faulty converter unit
When the product has been stored for an extended period of time, consult
Mitsubishi.
When treating the converter unit
such as the corners of the converter unit
POINT
Explanations on the following item are the same as those for servo amplifiers
with 22kW or less. Refer to the section below for details.
Keep out foreign materials Refer to section 2.2.
Cable stress Refer to section 2.3.
SSCNET cable laying Refer to section 2.4.
Parts Having Service Lives Refer to section 2.6.
drive unit to drop impact or shock loads as they
drive unit, be careful about the edged parts
drive unit.
13 - 20
drive unit. Otherwise,
drive unit.