Mitsubishi Electric Melservo-J3 Series MR-J3-B Instruction Manual page 137

5. PARAMETERS
No. Symbol
PC12 MO2 Analog monitor 2 offset
Used to set the offset voltage of the analog monitor2 (MO2) output.
PC13 MOSDL Analog monitor feedback position output standard data Low
Used to set the standard position of feedback output with analog monitor 1 (M01) or 2
(M02).
For this parameter, the lower-order four digits of standard position in decimal numbers
are set.
PC14 MOSDH Analog monitor feedback position output standard data High
Used to set the standard position of feedback output with analog monitor 1 (M01) or 2
(M02).
For this parameter, the higher-order four digits of standard position in decimal numbers
are set.
PC15 For manufacturer setting
Do not change this value by any means.
PC16
PC17 **COP4 Function Selection C-4
Home position setting condition in the absolute position detection system can be
selected.
0 0 0
PC18 For manufacturer setting
Do not change this value by any means.
PC19
PC20
PC21 *BPS Alarm history clear
Used to clear the alarm history.
0 0 0
PC22
For manufacturer setting
Do not change this value by any means.
PC23
PC24
PC25
PC26
PC27
PC28
PC29
PC30
PC31
PC32
Name and Function
Selection of home position setting condition
0: Need to pass motor Z phase after the power
supply is switched on.
1: Not need to pass motor Z phase after the power
supply is switched on.
Alarm history clear
0: Invalid
1: Valid
When alarm history clear is made valid, the alarm
history is cleared at next power-on.
After the alarm history is cleared, the setting is
automatically made invalid (reset to 0).
5 - 20
Initial Setting
Unit
Value Range
0 mV -999
to
999
0 pulse -9999
to
9999
0 10000 -9999
pulse to
9999
0
0000h
0000h Refer to
Name
and
function
column.
0000h
0000h
0000h
0000h Refer to
Name
and
function
column.
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h
0000h