LG 23CAV42K Owner's Manual page 35

<Figure 2-17: Advanced Settings for View Connection
Server>
y Desktop Name to Select
Enter the name of the pool/desktop which the
user client uses upon starting a session.
y Port
For the default setting, leave the port field
empty. When the VMware View Connection
Server uses the SSL authentication, enter 443
in the Port field.
If the server where a user tries to access uses
a port other than a general port, enter the port.
y Auto Connect
If this option is enabled, the selected VMware
View Connection Server is automatically con-
nected when the user client is powered on.
If the Auto Connect option is enabled, you
should turn the user client off and turn it on
again at least once.
y Remember Username
If this option is selected, the username which
is previously used to access the VMware View
Connection Server is automatically entered in
the username field.
y Auto Launch if Only One Desktop
If this option is selected, connection is estab-
lished to the desktop when there is only one
virtual desktop that a user wants to access.
y Use OSD logo for View banner
If this option is enabled, you can change the
OSD logo of PCoIP during the login.
NOTE
The OSD logo can be uploaded using the
y
Webpage Administration Interface.
Using CLOUD Solution
y Prefer GSC-IS
If this option is selected, the GCS-IS interface
is used when a smart card supports more than
one interface. If the smart card supports only
one interface, it is not used.
NOTE
This setting is provided only when a smart
y
card is used.
y Enable Peer Loss Overlay
If this option is selected, the "Network Con-
nection Lost" message is displayed on the
screen when it is confirmed that the network is
disconnected.
The display is the same as in the VDI environ-
ment. The default is Disable.
NOTE
This setting is provided only for the client.
y
y Enable Preparing Desktop Overlay
If this option is selected, the "Preparing Desk-
top" message is displayed on the screen when
the user is logged in.
y Disconnect Message Filter
This option determines the type of message to
display when a session is disconnected.
- Show All: Shows all the error messages.
- Show Error and Warning Only: Shows the
error and warning messages only.
- Show Error Only: Shows the error messages
only.
- Show None: Shows nothing.
35