Section 2. Getting Ready To Sew Connecting Machine To Power Supply; Reverse Stitch Control; Presser Foot Lifter - Janome Sewing Machine Instruction Book

2
5
4
3
2
3
1
Operating Instructions:
This appliance has a polarized plug (one blade
wider than the other). To reduce the risk of an
electric shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not
fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the
proper outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J or TJC-150 is used
with Sewing Machine Model 3128.

Reverse Stitch Control

Press the reverse stitch control to sew in reverse.

Presser Foot Lifter

3
The presser foot lifter raises and lowers the
presser foot.
2
You can raise it about 1/4" (0.6 cm) higher than
the normal up position for easy removal of the
1
presser foot, or to allow you to place heavy fabric
under the foot.
4
SECTION 2. GETTING READY TO SEW
Connecting Machine to Power Supply
1 Power supply plug
2 Power switch
3 Outlet
Power cord receptacle
4
5 Machine plug
Before connecting the power cord, make sure the
voltage and frequency shown on the machine
conform to your electrical power.
1. Turn off the power switch.
2. Insert the machine plug into the power cord
receptacle.
3. Insert the power supply plug into the outlet.
4. Turn on the power switch to turn on the power
and sewing light.
Presser foot lifter
1
Normal up position
2
Highest position
3