Wiring Diagram - Regency P33-LP3 Owners & Installation Manual

INSTALLATION
This heater does not require a 120V A.C. supply for operation. In case of a power failure, the burner switch and the optional remote control/thermostat
will continue to operate. However, a 120V A.C. power supply is needed for the fan/blower operation.
(Do not cut the ground terminal off under any circumstances.)
NOTE: Even if the fan is not purchased with the unit, it is still a good idea to bring power to the receptacle box (provided with the unit)
in case the fan is installed at a later date.
Lockwasher
Star washer
#8 Ground Lug
(mobile home
Nut
Fan
ground wire
White
Burner ON
OFF
Red
Thermostat
Black
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
CAUTION: Label all wires
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.

WIRING DIAGRAM

approved)
Pilot
Assembly
Piezo
Ignitor
(To THTP)
(To TH)
T-Stat
ON OFF
Remote Receiver
or Thermostat
(Millivolt) (Optional)
Ground
Neutral
Live
Ground
120V AC
60 Hz
ON
Rotary Speed
Control
Brown
White
To Thermocouple IN
"S.I.T" Valve
Remote Transmitter
(Optional)
Regency P33-3 Zero Clearance Direct Vent Gas Fireplace
Fan
Green
OFF
Black Red Red
Minimum Convection
Air Temp. Switch
Gas
In