Horizontal Terminations Only - Regency P33-LP3 Owners & Installation Manual

Zero clearance direct vent gas fireplace

Table of Contents

This venting system, in combination with the P33-3 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock

Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram on page 10.

Regency Direct Vent (Flex) System Termination Kit (Part # 946-513) includes all the parts needed to install the P33-3 with a maximum

run of 2 feet. If installing the P33 with a continuous vent length of more than 2 ft (.6m) to a maximum of 10 ft. (3.0m) using Kit # 946-515 (4 ft) or

946-516 (10 ft) or see page 13 for alternate venting arrangements.

1) 6-7/8" dia. ﬂ exible liner (2 ft. length)

2) 4" dia. ﬂ exible liner (2 ft. length)

3) spring spacers (3)

4) thimble (2)

5) AstroCap termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" drill point, stainless steel (4)

Notes:

1) Liner sections should be continuous without any

joints or seams.

2) Only Flex pipe purchased from Regency may be

used for Flex installations.

Important

If using any Cabinet Mantels with Part

# 510956, 510958, 510962, 510964

and 510834 the wall thimble must

be secured ﬁ rst and venting must be

attached to unit before sliding into

ﬁ nal position.

Also Simpson Dura-Vent venting can-

not be used with any of the mantels

noted above.

Minimum

Simpson Dura-Vent Center-Line

Regency P33-3 Zero Clearance Direct Vent Gas Fireplace

REGENCY DIRECT VENT SYSTEM (FLEX)