Startup - Hoshizaki KMD-410MAH Instruction Manual

I. Startup
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to
prevent damage to the compressor.
• To prevent damage to the water pump, do not leave the control switch in the
"SERVICE" position for extended periods of time when the water tank is empty.
• At startup, confi rm that all internal and external connections are free of leaks.
1) Open the water supply line shut-off valve.
2) Remove the front panel.
3) Move the control switch on the control box to the "ICE" position.
4) Replace the front panel in its correct position.
5) Turn on the power supply and allow the icemaker to operate for 5 minutes to fi ll up the
water tank.
6) Remove the front panel and move the control switch to the "SERVICE" position. Move
the service switch to the "WASH" position.
7) Replace the front panel in its correct position and allow the icemaker to run for 5
minutes.
8) Remove the front panel and move the service switch to the "DRAIN" position.
9) Replace the front panel in its correct position and allow the icemaker to drain for 2
minutes.
10) Turn off the power supply.
11) Remove the front panel and move the control switch to the "ICE" position.
12) Replace the front panel in its correct position.
13) Clean the storage bin/dispenser unit liner using a neutral cleaner. Rinse thoroughly
after cleaning.
WARNING
NOTICE
20