Installation Of The Icemaker; Setup - Hoshizaki Serenity Series KMS-2000MLH Instruction Manual

D. Installation of the Icemaker
• Power supply and ground wire to the icemaker are supplied from the remote
condensing unit. For details, see "II.F. Electrical Connection."
• Before operating the icemaker, the bin control must be installed correctly. Failure
to properly install the bin control could result in ice backup and unit damage.
• Failure to properly seal the icemaker to the dispenser unit/storage bin could result
in water leakage and costly water damage.

1. Setup

1) If mounting the icemaker on top of a dispenser unit, follow the dispenser unit's setup
procedure. If mounting the icemaker on top of a storage bin, unpack the storage bin and
attach the 4 adjustable legs provided (bin accessory) to the bottom of the storage bin.
2) Position the dispenser unit/storage bin in its permanent location.
2a) Dispenser Unit: Install the dispenser unit adapter kit. Make sure the dispenser
unit adapter kit opening and the icemaker water tank opening match. If not, cut the
dispenser unit adapter kit to the dimensions needed to match the icemaker water
tank opening. NOTICE! The dispenser unit adapter kit opening MUST match the
icemaker water tank opening. A smaller opening may result in water leaking.
Seal the adapter kit to the dispenser unit with RTV-748 sealant (provided) or
equivalent. See Fig. 5.
2b) Storage Bin: If required, install a top kit, a storage bin extension bracket HS kit, or
a brace HS kit. Contact your local Hoshizaki distributor for recommendations.
3) Place the icemaker on top of the dispenser unit/storage bin.
NOTICE
Dispenser Unit Application
25 mm 543 mm
[1 in.] [21.4 in.]
Fig. 5
15
Icemaker Water Tank Opening