Water Tank Removal - Hoshizaki Serenity Series KMS-2000MLH Instruction Manual

2. Water Tank Removal

1) Remove the front frame and splash curtain. See Fig. 7.
2) Disconnect the pump suction hose, drain pipe, and float connection hose at the
evaporator case wall. Disconnect the water tank drain hose from the bottom of the
water tank. Although the water tank can be removed at this point, do not remove it yet
because the bin control is taped inside the water tank.
The bin control cable is routed through the back of the icemaker. If care is not taken
when removing the water tank, the bin control cable could be severed.
Fig. 7
3) Pull out the water tank only as far as shown in Fig. 8.
4) Remove the cube guide, then remove the bin control assembly.
5) Being careful not to pull the bin control cable, remove the water tank completely
from the icemaker.
6) Remove the remaining pieces of tape from the water tank and leave the water tank out
of the icemaker for now.
Bin Control Cable
Fig. 8
Water Tank Drain Hose
Pump Suction Hose
Water Tank
Cube Guide
NOTICE
Drain Pipe
Float Connection Hose
17
Evaporator Case Wall
Splash Curtain
Front Frame