Icemaker - Hoshizaki KML-700MRJZ Instruction Manual

1. Icemaker

Icemaker Water Minimum Icemaker
Supply Inlet Water Supply Line Size
1/2" Female Pipe 1/4" Nominal ID
Thread (FPT) Copper Water Tubing or
Equivalent
• An icemaker water supply line shut-off valve and drain valve must be installed.
• Be sure there is sufficient extra water supply line and drain line for the appliance to be
pulled out for service.
Remote Condenser
Line Set Connections
(Remote Model)
Icemaker
Drain Outlet
3/4" FPT
Vent Tube
Bin Drain Outlet
3/4" FPT
Fig. 4 Air-Cooled and Remote Models
Model Shown:
KML-700MRJZ
Icemaker Drain
Outlet
3/4" Female Pipe
Thread (FPT)
Icemaker Water
Supply Inlet
1/2" FPT
Minimum 1/4" Nominal ID Copper
Water Tubing or Equivalent
Icemaker
Ice
Storage
Bin
Minimum 3/4" Nominal ID
Hard Pipe or Equivalent
17
Minimum Icemaker
Drain Line Size
3/4" Nominal
ID Hard Pipe or
Equivalent
Shut-Off Valve
Drain Valve
Be sure there is sufficient
extra water supply line and
drain line for the appliance
to be pulled out for service.
Separate piping to approved
drain. Leave a 2-inch (5-cm)
vertical air gap between the
end of each pipe and the
drain.
2-inch (5-cm) air gap
Floor Drain