13) Replace the splash curtain, front frame, and insulation panel in their correct positions
and secure with the thumbscrews.
14) Seal the outer perimeter of the front frame to the icemaker and dispenser unit/storage
bin with RTV-748 sealant (provided) or equivalent. See Fig. 19. Make sure the front
frame sealant meets the previously applied perimeter sealant and that there are no
gaps.
15) Move the control switch to the "ICE" position.
16) Replace the front panel in its correct position.
17) Turn on the power supply to start the automatic icemaking process.
Bin Control
Water Tank Drain Hose
Pump Suction Hose
Water Tank
Evaporator Case Wall
Drain Pipe
Splash Curtain
Front Frame
Float Connection Hose
Fig. 18
Seal the Front Frame Outer Perimeter with RTV-748 Sealant
or Equivalent. Make sure the front frame sealant meets the
Front Frame
previously applied perimeter sealant and that there are no gaps.
Fig. 19
Insulation Panel
31
Front Panel