Table of Contents
Advertisement
16) Has the end user been given the name and telephone number of an authorized service
agent?
17) Has the warranty card been filled out and forwarded to the factory for warranty
registration?
I. Startup
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• If the unit is turned off, wait for at least 3 minutes before restarting the unit to
prevent damage to the compressor.
• To prevent damage to the water pump seal, do not leave the control switch in the
"SERVICE" position when the water tank is empty.
• At startup, confirm that all internal and external connections are free of leaks.
• The remote condensing unit must have power for a minimum of 4 hours prior to
startup to prevent compressor damage.
1) If removed, replace the splash curtain, front frame, and all panels except the front panel
in their correct positions. See Fig. 18. If not already removed, remove the front panel.
2) Open the water supply line shut-off valve.
3) Move the control switch to the "ICE" position, then replace the front panel in its correct
position.
4) Turn on the power supply, and allow the water tank to fill with water and the icemaker to
operate for a total of 10 minutes.
5) After 10 minutes of operation, confirm bin control operation. Remove the front panel,
then press and hold the bin control's actuator paddle. The compressor and fan motor
should de-energize within 15 seconds, then the drain valve should energize until the
water tank empties. After the water tank empties, the pump motor and drain valve
should de-energize.
6) Move the control switch to the "OFF" position, then turn off the power supply.
7) Remove the insulation panel, front frame, and splash curtain.
8) Finish draining the water tank by disconnecting the pump suction hose at the evaporator
case wall.
9) Disconnect the drain pipe and float connection hose at the evaporator case wall.
Disconnect the water tank drain hose from the bottom of the water tank.
10) Remove the water tank.
11) Clean the dispenser unit/storage bin liner and water tank using a neutral cleaner. Rinse
thoroughly after cleaning.
12) Replace the water tank in the icemaker, then reconnect the hoses and drain pipe.
WARNING
NOTICE
30
Advertisement
Table of Contents
