Table of Contents
Advertisement
4
•
•
•
Í
1.2 Obtain installation tools
To install the core pack you will need the following items:
•
•
•
•
•
•
Note: You will also need the tools and equipment required to install
the control unit and drive unit. For full details, refer the information
supplied with control unit and drive unit.
1.3 Check parts supplied
Use the diagram on the following page to check the parts supplied.
CAUTION:
Before you start installing the course computer, check that it is
the correct voltage for your boat's power and your drive unit.
Type 150/400 Autopilot System: Installation Guide
handheld remotes (the ST600R full-function remote control or
the SeaTalk handheld remote control)
pushpit or masthead wind vanes (for sail boats without a suitable
wind instrument)
an external alarm (through an E85001 interface)
For more information about extended systems, see page 31.
tape measure (metric/imperial)
screwdrivers:
•
cross-head/pozi-drive
•
flat-bladed (large and small)
drill and 3 mm drill bit
center punch, pencil and masking tape
for the rudder position sensor:
•
hacksaw
•
small adjustable spanner
•
bolts, nuts and lockwashers (if required for tiller pin)
for the course computer power supply:
•
suitable power cable (see page 16)
•
suitable fuse/circuit breaker (see page 16)
Hide quick links:
Advertisement
Table of Contents
