Connecting Cables To The Terminals; Using The Fuses - Raymarine 150/400 Installation Manual

14

Connecting cables to the terminals

Power and Motor terminals
•
•
To secure cables in these terminals:
•
•
•
•
Other terminals
Note: All other terminals on the course computer will accept
stranded cable up to 2.5 mm
To secure cables to the other terminals:
•
•
•
•

Using the fuses

The POWER , MOTOR and SeaTalk terminals are fuse protected
against short-circuits and misconnections. To change the fuses:
•
•
Note: The course computer is supplied with three spare fuses fitted in
the case. The fuses used in the course computer are standard
automotive blade fuses, so you can easily obtain replacement fuses.
Your Raymarine dealer can also provide a replacement fuse pack
(part number: A18065).
Type 150/400 Autopilot System: Installation Guide
The POWER and MOTOR terminals on Type 150/150G course
computers accept stranded cable up to 4mm
The POWER and MOTOR terminals on Type 400/400G course
computers accept stranded cable up to 10 mm
1
strip 8–10 mm ( / in) of insulation from the end of each cable
2
use a small screwdriver to loosen the screw on the terminal block
insert the stripped cable into the terminal
tighten the screw
1
strip at least 5 mm ( /
use a small screwdriver to push the small plastic lever on top of
the terminal and release the cable clamp
insert the stripped cable
release the lever to grip the cable
use the fuse puller (supplied in the case) to remove the fuse
replace the fuse with an appropriate spare fuse
2
(14 AWG).
in) of insulation from the end of each cable
4
2
(12 AWG).
2
(8 AWG).