Operator Cycle Count; Gdo & Display Firmware - Genie GCL-GCX Manual

Operator Cycle Count

R N
1) Press CAL/RUN to enter calibration mode.
CAL
RUN
2) Press SCROLL until display reads "CYCLES>1,2,3 etc.
SCROLL
where the number is the number of open/close cycles the operator
has performed. Figure A.
3) Press CAL/RUN CAL to return to run mode.
RUN
GDO and Display Firmware
C
N
1) Press CAL/RUN CAL to enter calibration mode.
RUN
2) Press SCROLL until display reads "GDO V# > ######." Figure B.
SCROLL
This display will cycle between the version number of the current GDO
firmware and the current Display Firmware.
3) Press CAL/RUN to return to run mode.
CAL
RUN
GCL-GCX
Counter Door Operator
Section 7: Special Operator Features
P
www.geniecompany.com
(No user input)
OPEN
CYCLES 1
CLOSE
Figure A STOP
OPEN
GDO V# #########
CLOSE
STOP
OPEN
DISPLAY V# #######
CLOSE
STOP
Figure B
CAL SET
SCROLL
RUN CLEAR
08-12
7.1