Other Connectors - Foxconn 6100M2MA series User Manual

Other Connectors

This motherboard includes interfaces for FLOPPY, IDE devices, SATA IIdevices,
USB devices, 1394 devices, IR module, CPU fan, system fan, and others.
FLOPPY
This motherboard includes a standard FLOPPY interface, supporting 360 K, 720 K,
1.2 M, 1.44 M, and 2.88 M FDDs.
HDD connectors: PIDE & SIDE
These connectors support the UltraDMA 133/100/66 IDE hard disk ribbon cable.
Connect the cable's blue connector to the primary (recommended) or second-
ary IDE connector, then connect the gray connector to the UltraDMA 133/100/66/
33 slave device (hard disk drive) and the black connector to the UltraDMA 133/
100/66/33 master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FLOPPY connector on the motherboard.
Front Panel Connector: FP
This motherboard includes one connector for con-
necting the front panel switch and LED indicator.
16
Chapter 2 Installation Instructions
PLED PWRBTN#
1
HDD_LED RESET
+ -
+ -
NC
FP
FP!