Foxconn 6100M2MA series User Manual page 24

Hard Disk LED Connector (HDD_LED)
Attach the connector to the HDD_LED on the front panel of the case; the LED will
flash while the HDD is in operation.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PLED)
Attach the connector to the Power LED on the front panel of the case. The Power
LED indicates the power supply status. W hen the system is in S0 status, the
LED is on. W hen the system is in S1 status, the LED is blink. W hen the system
is in S3, S4, S5 status, the LED is off.
Power Switch Connector (PW RBTN#)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
USB Connectors: F_USB 1, F_USB 2
Besides four USB ports on the rear panel, the series of motherboards also have
two 10-pin headers on board which may connect to the front panel USB cable to
provide additional four USB ports.
1
VCC
D4-
D4+
GND
Empty
9
F_USB1
Fan Connectors: CPU_FAN, SYS_FAN
The fan speed of CPU_FAN and SYS_FAN can be detected and viewed in "PC
Health" section of the CMOS SETUP. These fans will be automatically turned off
after the system enters suspend mode.
Chapter 2 Installation Instructions
2
VCC
VCC
D6-
D5-
D6+
D5+
GND
GND
Empty
NC
10
GND +12V SENSE
1
CPU_FAN
1 2
VCC
D7-
D7+
GND
NC
9 10
F_USB2
GND
1
+12V
SENSE
SYS_FAN
17