Integrated Peripherals - Foxconn 6100M2MA series User Manual

Integrated Peripherals

vIDE Function Setup
Press Enter to set the items about IDE Function.
vRAID Config
Press <Enter> to set the items of Raid configuration.
vOnboard Device
Press <Enter> to set the items of onboard device.
vIDE HDD Block Mode
This option is used to set whether the IDE HDD Block Mode is allowed. The
available setting values are: Disabled and Enabled.
vOnboad FDC Controller
This option is used to set whether the onboard FDC controller is enabled.
vOnboard Serial Port 1/2
This option is used to assign the I/O address and interrupt request (IRQ)
for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
vUART Mode Select
Use this option to select the UART mode. The setting values include Normal,
IrDA, ASKIR and SCR. The setting value is determined by the infrared module
installed on the board.
vUR2 Duplex Mode
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infrared (IR) function of the onboard infra-
red chip. The available setting values are: Half and Full.
Integrated Peripherals Menu
Chapter 3 BIOS Description
35