Normal Recording - Zenith TVSC2040F Operating Manual & Warranty

This function enables you to set a recording
length simply by pressing the REC/OTR button on
the TV/VCR.
Make sure:
• TVNCR power must be turned on.
• Inserta cassette tape with its erase prevention
tab in place. (If necessary, rewind or fast
forward the tape to the point you want to begin
recording.)
NOTE:
• This function CANNOT be clone from the
remote control.
• Recording starts immediately when the
REC/OTR button is pressed.
• When the REC/OTR button is pressed 18
times, the TV/VCR returns to the Normal
Recording mode.
• To stop the OTR operation, press the STOP
button on the TVNCR or on the remote control.
• To show the remaining time, press the DISPLAY
button on the remote control so that "OTR"
appears on the TV screen. (It will show up
momentarily then disappear.)
• Recording stops when 0:00 is reached.
• Please note that in the SLP mode, maximum
recording time, is 8 hours using a T-160 or 6
hours using 1"-120tape.
• If the tape runs out before the end time, the
TV/VCR will switch to the Stop mode
immediately, ejects the tape and turns itself off.
1 Select the channel to be recorded
Press the number buttons on the remote control
or the CHANNEL UP or DOWN button.
Remember: If the TV/VCR is connected to a
cable box or satellite box, the TVNCR must be on
CH3 or CH4, then the channel to be recorded is
selected on the cable box or satellite box.
2 Select the tape speed
Press the SPEED button to select the desired
tape speed (SP/SLP).
3
Begin OTR
Press the REC/OTR button
once to begin recording.
Press twice to set recording length to 30 minutes.
Each additional push of the button will increase
the recording time by 30 minutes, up to a total of
480 minutes.
Push(es)
1 push
2 pushes
3 pushes
¢
17 pushe_
Display Recording length
(Begin Recording)
0:30 30 minutes
1:00 60 minutes
¢ ¢
8:00 480 minutes
Unauthorized recordings of copyrighted video
tapes may be an infringement of copyright
laws.
Connect your TV/VCR and a Source (Playing)
VCR using the following diagram.
Dn:_D_J;DDQ o_
ii __'=_" "..... _T'_: .... E[The TVNCR]
[Ex: Source (playing)
VCR or camcorder]
Audio/Video __
adapter cable _o _
(not supplied)
1) Insert a pre-recorded video cassette into the
Source (Playing) VCR or camcorder.
2) insert a blank video cassette, or one you want
to record over, into the TVNCR's cassette
compartment.
3) Press the SPEED button on remote control for
the rv/VCR to select the desired recording
speed (SP/SLP).
4) Press the CHANNEL UP or DOWN button on
the "TV/VCR until "AUX" appears on the screen,
5) Press the REC(ORD) button on the TV/VCR.
6) Begin playback of the tape in the source
(Playing) VCR or camcorder.
NOTE: For best results during copying, use the
TV/VCR's front panel controls whenever possible.
The remote control might affect the source
(Playing) VCR's playback operation.
- 26 - EN
9K16