Video Cassette - Zenith TVSC2040F Operating Manual & Warranty

20" color tv/vcr combination
Table of Contents

Advertisement

VIDEO CASSETTE
This TVNCR will operatewith any cassette that has the _
mark. For best results, we recommend
the use of high-quality tapes. Do not use poor quality or damaged tapes.
PRECAUTIONS
• Avoid moisture. Moisture condensation
may
occur inside the unit when it is moved from a
cold place to a warm place, or after heating a
cold room or under conditions of high humidity.
If a tape is played in a TVNCR
which has
moisture, it may damage the tape and TV/VCR.
Therefore when you suspect that condensation
has occurred inside the unit, turn the POWER
button ON and allow at least 2 hours for the unit
to dry out.
• Avoid extreme heat, high humidity and
magnetic fields.
• Do not tamper with the cassette mechanism.
• Do not touch the tape with your fingers.
TAPE SPEEDS
You may choose to recordat two different tape
speeds:
• SP-Standard Play
• SLP- Super Long Play
The table below shows the maximum
recording/playback time usingT60, T120 or T160
tapes in each mode,
Tape Speed
Recording/Playback Time
Type of
tape
T60
T120
T160
SP mode
1 hour
2 hours
2-2/3 hours
SLPmode
3hours
6hours
8 hours
NOTE: You can play back a tape recorded in LP
(Long Play) mode.
INSERTING
A CASSETTE
Position cassette with the view-window
facing up,
as pictured below. Insert cassette into cassette
slot by pushing in gently, but continuously, on the
center of the cassette back until cassette is drawn
into the TV/VCR.
Once cassette is fully inserted, the TV/VCR will
automatically
turn on.
CORRECT
WRONG
REMOVING
A CASSETTE
1) With the TVNCR in the Stop mode, press the
EJECT button on the remote control,or press
the STOP/EJECT button on the TVNCR. The
cassette will eject.
2) Pull the cassette out of the cassette
compartment.
3) Store the cassette in its case as shown.
ERASE PREVENTION
You can prevent accidental
erasing of recording by
breaking off the tab on the
back edge of the cassette.
If you decide to record on
the tape again, cover the
hole with plastic tape.
Transparent Tape
-8-
EN
9K16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents