Zenith TVSC2040F Operating Manual & Warranty page 12

CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE BOX
You cable system may require a converter box, or
if you use a satellite system, you will need a
satellite box. in each case, you must connect a 75
ohm coaxial cable (not supplied) from the cable
system wall outlet to the box, and another 75 ohm
coaxial cable from the box to the Antenna
terminal of your TVNCR. See below.
____ Satellite Box or
;N _ Cable Box (Not supplied)
'/ _ From Cable System
or Satellite Dish
TO RECORD A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the "I'V/VCRchannel selectorto the output
channel(3or 4) of the cable or satellite box.
2. Select the channel to be recorded or viewed
on the cable or satellite box.
1) Open the battery compartment cover by
pressing the cover on the remote unit in the
direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3) Replace the cover.
When using an external input signal (another
VCR or video camera), connect the player's
audio/video output cables to
the AUDIO INNIDEO IN AUX
jacks of your "rVNCR. Then
press the CHANNEL UP or
DOWN button until "AUX"
appears on the screen.
- 12- EN
9K16