Heat & Glo Escape-42DV Owner's Manual page 49

Step 2.
Place the grate onto the burner. The
back of the right tine drops into the
hole on the right rear of the burner.
Line the grate up so it is parallel with
the front of the fi rebox. Be sure to
push the grate all the way down to
the fl oor.
LOG #1
(SRV2012-081) (Three):
There are quantity three (3) of Log
#1. Place one of the logs on the fl oor
of the fi replace on the left side of the
grate between the fi rebox and the
left grate tine. Place the second log
on the right side of the burner be-
tween the burner and the right grate
tine. The second log can be slightly
resting on the edge of the burner.
Place third log on top of the left side
of the burner. The burner ports will
be around the log. Do NOT cover
any burner ports with the log.
LOG #2 (SRV2012-082) (Two):
There are quantity 2 (two) of Log #2. Place one of the logs
on the right side of the burner on the fl oor (see Figure A).
The log will be in front of the orange Kapton lens.
Figure A
2
1
2
Heat & Glo • Escape-42DV • 2052-900 Rev. Y • 11/11
1
Place the right end of the second log on the pilot bracket.
The left end of the log should rest on the base of the fi rebox
See Figure B.
Figure B
1
49