Mobile Home Installation - Harman Super-Magnum Owner's Manual

Super-Magnum Coal Stoker Stove
6
Mobile Home
A. Mobile Home Installation
Mobile home approval - U.S. only.
1. An outside air inlet must be provided for combustion
air, and must remain clear of leaves, debris, ice, and/or
snow. The outside air path must be unrestricted while the
appliance is in operation.
2. The combustion air intake system must be of metal
construction. It must permit zero-clearance to combustible
materials, and contain a rodent screen.
3. The appliance must be secured to the mobile home
structure by bolting it to the floor. There are brackets
included, you'll need to secure with the proper length lag
bolts.
4. The appliance must be grounded to the metal framing of
the mobile home
5. All clearances to combustibles and floor protection
requirements must be followed.
6. Follow the vent manufacturer's instructions when
installing in a mobile home.
7. Installation shall be in accordance with the Manufactured
Home and Safety Standard (HUD) CFR 3280, Part 24
8. The appliance must never be installed in a room
designated for sleeping.
!
Installation must comply with Manufactured Home and
Safety Standard (HUD), CFR 3280, Part 24.
!
Never install in a room intended for sleeping.
3-90-02702R6_03/13
WARNING
WARNING
CAUTION
Maintain structural integrity of mobile home:
• Floor, wall, ceiling and/or roof.
Do NOT cut through:
• Floor joist, wall studs, or ceiling trusses.
• Any supporting material that would affect the
structural integrity.
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity.
• Enclosed space such as an attic or garage
This diagram shows the bracket that was used to bolt the
stove to the pallet. Use at least two of these brackets for
securing the appliance through the floor in a mobile home
installation. The bracket will slip over the top of the leveling
adjuster. The installer will need to determine and obtain the
properly sized lag bolts.
Do Not Burn Wet Coal! 15