Out-Of-Balance Recovery Routine/Reset Back To Factory Settings - Fisher & Paykel AquaSmart WL70T60D Installation Instructions Manual

Out-of-Balance recovery routine
When your AquaSmart™ is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to  times. If it still senses an unbalanced
load there are two options the machine can take.
Automatic Recovery option
Your AquaSmart™ will try to automatically correct the
out-of-balance load. It will fill with water and agitate to
redistribute the load before trying to spin up again.
Machine Stops option
Your AquaSmart™ will stop, give a short burst of beeps
every 5 seconds, and the spin speed lights will flash. You
must redistribute the load more evenly yourself. (Use
this option if you wish to conserve water).
Your washer arrived with the 'Machine Stops' option set.
Enter Options Adjustment mode (refer to page 0).
1
Select SOAK to program your AquaSmart™ to
2
automatically recover.
Press POWER to save your selection.
3
Reset Back to Factory Settings
If you would like to reset all settings back to those that
were set when your AquaSmart™ left the factory you have
the option of selecting RESET DEFAULTS.
Enter Option Adjust Mode (refer to page 0).
1
Press and hold the START /PAUSE button until you hear
2
one quick beep. This indicates that all settings have been
returned to the factory default settings.
Changing pre-set options
Fig.17 Adjusting Out-of-Balance
recovery routine
SOAK
light on = automatic recovery
SOAK
light off = machine stops
Fig.18 Resetting factory defaults