Out-Of-Balance Recovery Routine/Reset Back To Factory Settings - Fisher & Paykel AquaSmart WL37T26D Installation Instructions And User Manual

Out-of-Balance recovery routine
When your AquaSmart™ is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
Automatic Recovery option
Your AquaSmart™ will try to automatically correct the
out-of-balance load. It will fill with water and agitate
to redistribute the load before trying to spin up again.
Machine Stops option
Your AquaSmart™ will stop, give a short burst of
beeps every 5 seconds, and the spin speed lights will
flash. You must redistribute the load more evenly
yourself. (Use this option if you wish to conserve
water).
Your washer arrived with the 'Machine Stops'
option set.
Enter Options Adjustment mode (refer to page 28).
1
Select SOAK to program your AquaSmart™ to
2
automatically recover.
Press POWER to save your selection.
3
Reset Back to Factory Settings
If you would like to reset all settings back to those
that were set when your AquaSmart™ left the factory
you have the option of selecting RESET DEFAULTS.
Enter Option Adjust Mode (page 28).
1
Press and hold the START /PAUSE button until you
2
hear one quick beep. This indicates that all settings
have been returned to the factory default settings.
changing pre-set options
Fig.18 Adjusting Out-of-Balance
recovery routine
Fig 19. Resetting factory defaults
SOAK
light on = automatic recovery
SOAK
light off =machine stops
31
EN