Out Of Balance Recovery Routine; Specifications - Fisher & Paykel GW711 Use And Care Manual

CHANGING PRE-SET OPTIONS
20
OUT-OF-BALANCE
RECOVERY ROUTINE
MACHINE INFORMATION

SPECIFICATIONS

Model Capacity
GW711 7.5kg
GW611 6.5kg
GW511 5.5kg
MW511 5.5kg
MWC11
• Electrical Supply
• Inlet Water Pressure
• Standpipe Height
Note: Exact height of your Smart Drive is dependent on how far the feet are inserted
onto the base of the machine.
*Height is measured to the highest point on the console.
When your Smart Drive is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
•
REGULAR
light on
= automatic
recovery
•
REGULAR
light off
=machine
stops
Depth
650mm
600mm
560mm
560mm
220-240V, 50Hz Sinusoidal, 165W
Max. 1MPa (150 psi) Min. 20kPa (3 psi)
850-1200mm
AUTOMATIC RECOVERY OPTION
Your Smart Drive will try to automatically correct
the out-of-balance load. It will fill with water and
agitate to redistribute the load before trying to
spin up again.
MACHINE STOPS OPTION
Your Smart Drive will stop, give a short burst of
beeps every 5 seconds, and the RINSE or SPIN
light will flash. You must redistribute the load
more evenly yourself. (Use this option if you wish
to conserve water).
Width Height*
650mm 1020-1050mm
600mm 1020-1050mm
560mm 1020-1050mm
560mm 1020-1050mm
Height (Lid Open)
1410-1440mm
1360-1390mm
1320-1350mm
1320-1350mm
23