Out Of Balance Recovery Routine; Machine Information Specifications - Fisher & Paykel WA75T65GW1 Installation Instructions And User Manual

Changing pre-set options
26

Out of balance recovery routine

When your Smart Drive™ is spinning it can sense if the wash load is out of balance and will stop
and re-try spinning up to three times. If it still senses an unbalanced load there are two options
the machine can take.
Automatic recovery option
Your Smart Drive™ will try to automatically correct the out of balance load. It will fill with water
and agitate to redistribute the load before trying to spin up again.
Machine stops option
Your Smart Drive™ will stop, give a short burst of beeps every five seconds, and the RINSE or
SPIN light will flash. You must redistribute the load more evenly yourself (use this option if you
wish to conserve water).
REGULAR
light on
= automatic recovery
Machine information
Specifications
Model
WA75T65GW1
WA65T60GW1
WA55T56GW1
WA55T56MW1
(MW512)
Electrical Supply: 220 – 240 V, 50 Hz Sinusoidal, 165 W
Inlet Water Pressure: Max. 1 MPa (150 psi) Min. 34 Pa (5 psi)
Inlet Water Flow Rate: Min. 3 litres/min
Standpipe Height: 850 – 1200 mm
Note: exact height of your Smart Drive™ is dependent on how far the feet are inserted onto the
base of the machine.
* Height is measured to the highest point on the console.
4323_NZ_AU_PAC_GW_MW_Washer_UG11.indd 26
EXCELLENCE
REGULAR
light off
= machine stops
Fig.31 Adjusting the Out of balance recovery routine
Capacity Depth
7.5 kg 650 mm
6.5 kg 600 mm
5.5 kg 560 mm
5.5 kg 560 mm
PRIDE
REGULAR
light on
= automatic recovery
Width Height*
650 mm 1020 – 1050 mm
600 mm 1020 – 1050 mm
560 mm 1020 – 1050 mm
560 mm 1020 – 1050 mm
REGULAR
light off
= machine stops
Height (lid open)
1410 – 1440 mm
1360 – 1390 mm
1320 – 1350 mm
1320 – 1350 mm
8/10/09 2:45:27 PM