GE PGS908 Owner's Manual page 15

Usin the clock and timer.
GEAppliances.com (U.SJ
www.GEAppliances.ca (Canada)
I ClOcK I
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
J-_ Touch the CLOCKpad.
[] Touch the number pads.
J-_ Touch the STARTpad.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
To Set the Timer
[-7-1 Touch the KITCHENTIMERON/OFF pad.
Touch the number pads until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
touch 2, 4 and 5 in that order. If you
make a mistake touch the KITCHEN
TIMERON/OFF pad and begin again.
[] Touch the STARTpad.
After touching the START pad, SET disappears;
this tells you the time is counting down,
although the display does not change until one
minute has passed. Seconds will not be shown
in the display until the last minute is counting
down.
%
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the KITCHENTIMER
ON/OFF padis touched.
The6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by touching the KITCHEN
TIMERON/OFF pad, then touch the number
pads until the time you want appears in the
display.
If the remaining time is not in the display
(clock, delay start or cooking time are in the
display), recall the remaining time by touching
the KITCHENTIMERON/OFF pad and then
touching the number pads to enter the new
time you want.
To Cancel the Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.
15