GE Quickset III Owner's Manual page 30

Cleaning the glass cooktop,con some mode s;
Clean your cooktop after
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.
Normal Daily Use Cleaning
ONLYuse CERAMABRYTE ® Ceramic
Cooktop Cleaneron the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of
your glass cooktop, follow these steps:
Ffl
Before using the cooktop for the
first time, cleon it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes
cleanup easier.
r_ Daily use of CERAMABRYTE ® Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
%
%
Shakethe cleaning cream well.
Apply a few drops of CERAMABRYTE ®
Ceramic Cooktop Cleaner directly
to the cooktop.
Usea paper towel or CERAMA
BRYTE ® Cleaning Pad for Ceramic
Cooktops to clean the entire cooktop
surface.
[] Use a dry cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO
NOT heat the cooktop until it has been
cleaned thoroughly.
Use a CERAMA BRYTE ® Cleaning
Pad for Ceramic Cooktops.
Burned-On Residue
NOTE: DAMAGEto your glass surface
may occur if you use scrub pads other
than those recommended.
r_ Allow the cooktop to cool.
[] Spread a few drops of CERAMA
BRYTE ®Ceramic Cooktop Cleaner
on the entire burned residue area.
@
Using the included CERAMABRYTE ®
Cleaning Padfor Ceramic Cooktops,
rub the residue area, applying
pressure as needed.
r_ if any residue remains, repeat
the steps listed above as needed.
@
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
The CERAMA BRYTE ® Ceramic
Cooktop Scraper and all
recommended supplies are
available through our Parts
Center. See instructions under "To
Order Parts" section on next page.
NOTE: Do not use a dull or
nicked blade.
Heavy, Burned-On Residue
Allow the cooktop to cool.
Use
a single-edge razor blade
scraper at approximately a 45°
angle against the glass surface and
scrape the soil. It will be necessary
to apply pressure to the razor
scraper in order to remove the
residue.
@
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE ®Ceramic Cooktop
Cleaneron the entire burned residue
area. Use the CERAMABRYTE ®
Cleaning Pad to remove any
remaining residue.
%
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner
and a paper towel.
30