GE Quickset III Owner's Manual page 35

GEAppliances.com
Possible Causes What To Do
Storage drawer Rear drawer support is • Reposition the drawer. See the Storage Drawer
is crooked on top of the guide rail. Removal instructions in the Care and cleaning
of the range section.
Storage drawer Power cord may be • Repositionthe drawer and power cord. See the
wont close obstructing drawer Storage Drawer Removal instructions in the Careand
in the lower back cleaning of the range section.
of the range.
Rear drawer support is • Reposition the drawer. See the Storage Drawer
on top of the guide rail. Removal instructions in the Care and cleaning of the
range section.
Oven will not self-clean The oven temperature is • Allow the oven to cool to room temperature and
too high to set a self-clean reset the controls.
operation.
Oven controls improperly set. • See the Using the self-cleaning oven section.
Oven door is not in the locked • Hake sure you move the door latch handle all the
position, way to the right.
"Crackling" or This is the sound of the • This is normal.
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the Clear/Off pad. Open the windows to
during a clean cycle rid the room of smoke. Wait until the light on the
Self Clean pad goes off. Wipe up the excess soil and
reset the clean cycle.
Oven door will not Oven too hot. • Allow the oven to cool below locking temperature.
unlock
Oven not clean after Oven controls not properly set. • Seethe Using the self-cleaning oven section.
a clean cycle Oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"F-"and a number You have a function • Disconnect all power to the range for at least
or letter flash error code. 30 seconds and then reconnect power. If the function
in the display error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, from the locked position. Hake sure the latch
is moved to the right as far as it will go. Touch the
Clear/Off pad. Allow the oven to cool for one hour.
Putthe oven back into operation.
Water remaining on This is normal.
oven floor after Steam
Clean cycle
• Remove any remaining water with a dry cloth
or sponge.
35