Power Outage - GE Quickset III Owner's Manual

Using the oven control clock
and timer features and settings.
Throughout this manual, features and appearance may vary from your model.
0
(_Self-_
L_geonJ
SelfClean Pad
Touch this pad to selectthe self-cleaning function.
See the Using the self-cleaning oven section.
SelfClean Light
Flasheswhile in edit mode-you can change the
length of time for the self-clean cycle at this point.
Glows when the oven is in the self-clean cycle.After
the self-clean cycle, the light will turn off. Unlatch
the door.
Indicator Lights
EDITmode lasts several seconds after the last pad
press.Start Time On/Off and Cooking Time On/Off
will be the only pads lit if either of these options
is selected. (Example:Start Time is selected with
Bake-the Start Time pad will remain lit until the
clock reaches the programmed time, at which point
it will turn off and the Bake/Temp Recall pad light
will light up.)
_nvect _
/Bake|
Temp Rec_
I%eo '/
Meon J
L or_j
CBro!l-_
Hi/Lo
Convection Bake/Temp Recall
Touch this pad to select baking with the convection
function.
Steam Cleon
Touch this pad for easier cleaning, light soiling
of the oven cavity or door.
Clear/Off Pad
Touch this pad to cancel ALL oven operations
except the clock and timer.
Broil Hi/Lo Pad
Touch this pad to selectthe broil function.
Broil Light
Flasheswhile in edit mode-you can switch from
Hi to Lo Broil at this point. Glows when the oven
is in broil mode.
Power Outage
If a flashing time is in the display,you have
experienced a power failure. Resetthe clock.
To reset the clock, touch the Clock pad. Enter the
correct time of day by touching the + or - pads.
Touch the Start/On pad.
Using the oven.
To avoid possible burns, place the racks in the desired position before you turn the oven on.
B
, i
Number of rack positions vary by
model.
12
Before you begin...
Therackshavestop-locks, s othat whenplaced
correctlyon the racksupports, t hey will stop
beforecomingcompletelyout andwill not tilt.
Whenplacingand removingcookware, p ull
the rackout to the bumpon the racksupport.
Toremovea rack, pull it towardyou,tilt the
front end up and pull it out.
Toreplace, placethe endof the rack
(stop-locks) on the support,tilt up thefront
and pushthe rackin.
[-& CAUTION
Whenyou are usingthe rack in the lowest
position(A), you willneedto usecautionwhen
pullingthe rack out.We recommendthat you
pullthe rackout severalinchesand then,using
two pot holders, p ullthe rackout by holding
the sidesof it. Therackis low andyou couldbe
burnedif you placeyourhand in the middleof
the rack and pullall the way out. Bevery careful
notto burnyour handon the door whenusing
the rack in the lowestposition(A).